Yaskawa iQpump Drive User Manual User Manual
Page 25
1.9 Removing/Attaching the Digital Operator and Front Cover
YASKAWA TM.iQp.01 iQpump Drive User Manual
25
1.9
Removing/Attaching the Digital Operator and Front Cover
◆ Models CIMR-P7U20P4 through 2018 (0.5HP to 25HP @ 208V/240V) and
40P4 through 4018 (0.5HP to 30HP @ 480V)
For Models CIMR-P7U2018/4018-107 and smaller, remove the terminal cover and then use the following procedures to remove the
Digital Operator and front cover.
■
Removing the Digital Operator
Press on the side of the Digital Operator in the direction of arrow 1 to unlock, then lift the Digital Operator in the direction of arrow 2 to
remove it as shown in
.
Figure 1.15 Removing the Digital Operator
■
Removing the Front Cover
Press the left and right sides of the front cover in the direction of arrows 1 and lift the bottom of cover in the direction of arrow 2 to
remove it as shown in
.
Figure 1.16 Removing the Front Cover
■
Attaching the Front Cover
Mount the front cover to the iQpump drive by performing the steps to remove the front cover in reverse order.
1. Do not mount the front cover with the Digital Operator attached to the front cover; this may cause the Digital Operator to malfunction
due to imperfect contact.
2. Insert the tab of the upper part of the front cover into the groove of the iQpump drive and press the lower part of the front cover onto
the iQpump drive until the front cover snaps into place.
2
1
1
2