Yaskawa iQpump Drive User Manual - Manual (Page 126)

5.1 iQpump Basic Programming Parameters
126 YASKAWA TM.iQp.01 iQpump Drive User Manual
A successful VERIFY of the parameter values will display:
If all the parameter values stored in the digital operator do not match those programmed in the iQpump drive, the digital operator displays
the following:
The digital operator will not display which parameters did not match, only that the verification found discrepancies in some parameter
values.
Note: In order to properly use the COPY or VERIFY functions, the following iQpump drive specifications must be identical
between the iQpump drive that the parameters were read from and the iQpump drive that the parameters are to be
written to:
• Model Number (e.g. CIMR-P7U2015-107)
• Software Number (e.g. 30030 also known as FLASH ID)
Yaskawa offers DriveWizard™ software that can also READ, COPY, and VERIFY iQpump drive parameter values. DriveWizard™ lists
all discrepancies between the iQpump drive and a pre-saved parameter file when verifying is performed.
To use DriveWizard first select o2-15 = “0: Disabled” and select o2-06 = “0: Disabled” then remove the digital operator/keypad and
attach the DriveWizard cable in its place.
.
-ADV-
VERIFY
DATA VERIFYING
-ADV-
VERIFY
VERIFY COMPLETE
-ADV-
VYE
VERIFY ERROR