Yaskawa iQpump Drive User Manual - Manual (Page 60)

3.5 Pump Quick Setup Menu (-QUICK-) <0032>
60 YASKAWA TM.iQp.01 iQpump Drive User Manual
3.5 Pump Quick Setup Menu (-QUICK-)
<0032>
This menu is used to set/read the most commonly used parameters in the iQpump drive. Follow the key operations below ( Figure 3.6 ) to
access the Pump Quick Setup Menu
Figure 3.6 Pump Quick Setup Parameter Access Procedure
Use and keys to scroll through the Quick Setting Parameter List.
Table 3.11 Pump Quick Setup Parameter List
Parameter
Number
Parameter Name
E2-01 Motor Rated Current
E2-04 Number of Motor Poles
b1-02 Run Command Selection
b1-01 Frequency Reference Selection
P1-02 System Units
P1-03 Feedback Device Scaling
b5-12 PI Feedback Ref Missing Detection Selection
b5-13 PI Feedback Loss Detection Level
b5-14 PI Feedback Loss Detection Time
P1-04 Start Level
P1-05 Start Level Delay Time
P2-01 Sleep Level Type
P2-02 Sleep Level
P2-03 Sleep Delay Time
P1-06 Minimum Pump Frequency
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
P5-01 Hand Mode Reference Source
P5-02 Hand Reference
P1-11 Pump Protection Level
P1-12 Pump Protection Time
P1-14 Prime Loss Level
P4-09 Loss of Prime Maximum Restart Time After Fault
L5-01 Number of Auto Restart Attempts
L5-03 Maximum Restart Time After Fault
P4-08 Protection Fault Auto Restart Enable
P4-07 Feedback Fault Auto Restart Enable
P1-07 Low Feedback Level
P1-08 Low Feedback Level Fault Delay Time
P1-09 High Feedback Level
P1-10 High Feedback Level Fault Delay Time
P2-10 Maximum Setpoint Compensation
P4-01 Pre-Charge Level
P4-02 Pre-Charge Frequency
P4-03 Pre-Charge Time
P4-04 Thrust Bearing Acceleration Time
P4-05 Thrust Bearing Frequency
P4-06 Thrust Bearing Deceleration Time
P4-10 Auto Mode Operator Run Power Down Storage
x2
Pump Quick Setup
b1-01 =