Yaskawa iQpump Drive User Manual - Manual (Page 55)

3.4 Drive Main Menu
YASKAWA TM.iQp.01 iQpump Drive User Manual 55
◆ Stop Indicator
The status of the “STOP” indicator is shown in Table 3.6 when the iQpump drive is in either the “Hand” or “Auto” mode.
Table 3.6 STOP Indicator
3.4 Drive Main Menu
The iQpump drive’s parameters and monitoring functions are organized into menu groups that make it easier to read and set parameters.
The iQpump drive is equipped with five menu selections. The five selections and their primary functions are shown in Table 3.7 and are
directly available by pressing the MENU key.
Table 3.7 iQpump Drive Menu Selections
Indicator Status Condition
On Drive is decelerating to a stop or stopped
Blinking Drive is in a run condition but the frequency reference is zero or Drive is running in “Auto” mode and OFF has been pressed
Off Drive is running
Main Menu Primary Function(s)
Operation
- DRIVE -
The Drive can be run in this menu.
Use this menu for monitoring values such as frequency reference or output current, displaying fault history or displaying the
fault traces.
Pump Quick Setup
- QUICK -
The Drive can be programmed in this menu.
Use this menu to set/read the most commonly used parameters.
Programming
- ADV -
The Drive can be programmed in this menu.
Use this menu to set/read every parameter.
Modified Constants
- VERIFY -
The Drive can be programmed in this menu.
Use this menu to set/read the parameters that have been modified from their factory default settings.
Auto-Tuning
- A.TUNE -
The Drive can be programmed in this menu.
Use this menu to auto-tune the Drive in order to optimize motor control as well as utilize the bi-directional speed search feature.