Yaskawa iQpump Drive User Manual - Manual (Page 198)

198 YASKAWA TM.iQp.01 iQpump Drive User Manual
B.1 Drive Capacity
B.1 Drive Capacity
Parameter o2-04 sets the iQpump drive capacity according to the model number. Parameter o2-04 will need to be adjusted when
replacing a control board.
If a Control PCB is changed, the first time the iQpump drive is powered up, parameter o2-04 must be set to the appropriate value listed in
Table B.1 for the iQpump drive model number. After properly setting parameter 02-04, a 2-wire or 3-wire initialization must be
performed by setting parameter A1-03 = 2220 or A1-03 = 3330, respectively. This will automatically program the values of all other
parameters listed in Table B.2 to the factory settings for that particular iQpump drive rating.
Table B.1 Drive Capacity Selection
Voltage Model Number (CIMR-P7U ‰ -107) o2-04 Setting Nominal Hp
208-240 VAC
CIMR-P7U20P4 0 0.5/0.75
CIMR-P7U20P7 1 1
CIMR-P7U21P5 2 1.5/2
CIMR-P7U22P2 3 3
CIMR-P7U23P7 4 5
CIMR-P7U25P5 5 7.5
CIMR-P7U27P5 6 10
CIMR-P7U2011 7 15
CIMR-P7U2015 8 20
CIMR-P7U2018 9 25
CIMR-P7U2022 A 30
CIMR-P7U2030 B 40
208-230 VAC
CIMR-P7U2037 C 50
CIMR-P7U2045 D 60
CIMR-P7U2055 E 75
CIMR-P7U2075 F 75/100
CIMR-P7U2090 10 125
CIMR-P7U2110 11 150
480 VAC
CIMR-P7U40P4 20 0.5/0.75
CIMR-P7U40P7 21 1
CIMR-P7U41P5 22 1.5/2
CIMR-P7U42P2 23 3
CIMR-P7U43P7 24 5
CIMR-P7U45P5 26 7.5
CIMR-P7U47P5 27 10
CIMR-P7U49P0 3C 15
CIMR-P7U4011 28 20
CIMR-P7U4015 29 25
CIMR-P7U4018 2A 30
CIMR-P7U4024 3D 40
CIMR-P7U4030 2C 50
CIMR-P7U4037 2D 60
CIMR-P7U4045 2E 75
CIMR-P7U4055 2F 100
CIMR-P7U4075 30 125
CIMR-P7U4090 31 150
CIMR-P7U4110 32 200
CIMR-P7U4160 34 250
CIMR-P7U4185 35 300/350
CIMR-P7U4220 36 400/450
CIMR-P7U4300 37 500+
.