SMA SC 500CP-US-10 600V - Manual (Page 96)

13 Parameters SMA America, LLC
96 SCCP-US-BE-US_en-52 Operating Manual
PF-WLockInVtg** Power at which the cos
φ(P) characteristic curve
is activated, in % relative
to the nominal voltage
0% to 110% ‒ 0%
PF-WLockOutVtg** Power at which the cos
φ(P) characteristic curve
is deactivated, in %
relative to the nominal
voltage
0% to 110% ‒ 0%
PF-WLockTm** Waiting time for
activating or deactivating
the cos φ(P) characteristic
curve
0 s to 100 s ‒ 2 s
Q-VDif** Definition or the voltage
change that leads to a
reactive power change.
0.1% to 10% The value corresponds to
the nominal voltage VRtg.
1%
Q-VArGra** Definition of the reactive
power setpoint change
during a voltage step.
0% to 100% The value corresponds to
the nominal power Pmax.
1%
Q-VDifTm** Time span in which a
voltage change must be
present before the
reactive power target
value Q-VArGra
changes.
0 s to 120 s ‒ 1 s
Q-VRtgOfsNom** Changes the nominal
voltage VRtg of the
voltage-dependent
reactive power control
The parameter is active
only if parameter
Q-VArMod is set to
VArCtlCol.
− 10% to +10% ‒ 0%
Q-VArGraNom** Reactive power gradient 0%/V to 40.06%/V SC 500CP-US-10 0%/V
0%/V to 54.15%/V SC 500CP-US-10 600V
0%/V to 31.47%/V SC 630CP-US-10
0%/V to 27.82%/V SC 720CP-US-10
0%/V to 26.70%/V SC 750CP-US-10
0%/V to 25.04%/V SC 800CP-US-10
0%/V to 23.56%/V SC 850CP-US-10
0%/V to 22.25%/V SC 900CP-US-10
Q-VolWidNom** Voltage range 0% to 20% ‒ 0%
Q-VolNomP1** Voltage at point 1 80% to 120% ‒ 100%
Name Description Value/range Explanation Default
value