HEIDENHAIN iTNC 530 (340 49x-04) - Manual (Page 788)

M109
M110
M111
Constant contouring speed at tool cutting edge
(increase and decrease feed rate)
Constant contouring speed at tool cutting edge
(feed rate decrease only)
Cancel M109/M110 „
„
„
Page 313
M114
M115 Automatic compensation of machine geometry when working with tilted axes
Reset M114 „
„
Page 326
M116
M117 Feed rate for angular axes in mm/min
Cancel M116 „
„
Page 323
M118 Superimpose handwheel positioning during program run „ Page 316
M120 Pre-calculate radius-compensated contour (LOOK AHEAD) „ Page 314
M124 Do not include points when executing non-compensated line blocks „ Page 308
M126
M127 Shortest-path traverse of rotary axes
Cancel M126 „
„
Page 324
M128
M129 Retain position of tool tip when positioning tilting axes (TCPM)
Reset M128 „
„
Page 327
M130 Moving to position in an untilted coordinate system with a tilted working plane „ Page 306
M134
M135 Exact stop at nontangential contour transitions when positioning with rotary axes
Reset M134 „
„
Page 330
M136
M137 Feed rate F in millimeters per spindle revolution
Reset M136 „
„
Page 313
M138 Selection of tilted axes „ Page 330
M140 Retraction from the contour in the tool-axis direction „ Page 317
M141 Suppress touch probe monitoring „ Page 319
M142 Delete modal program information „ Page 320
M143 Delete basic rotation „ Page 320
M144
M145
Compensating the machine’s kinematics configuration for ACTUAL/NOMINAL positions at
end of block
Reset M144 „
„
Page 331
M148
M149 Retract the tool automatically from the contour at NC stop
Cancel M148 „
„
Page 321
M150 Suppress limit switch message (function effective blockwise) „ Page 322
M200
M201
M202
M203
M204 Laser cutting: Output programmed voltage directly
Laser cutting: Voltage output varies with the distance
Laser cutting: Voltage output varies with the velocity
Laser cutting: Voltage output varies with the time (ramp)
Laser cutting: Output voltage as a function of time (pulse) „
„
„
„
„
Page 332
M Effect Effective at block... Start End Page