beautypg.com

2 t ool d a ta – HEIDENHAIN iTNC 530 (340 49x-04) User Manual

Page 203

background image

HEIDENHAIN iTNC 530

203

5.2 T

ool D

a

ta

Tool table: Tool data for automatic speed/feed rate calculation

Tool table: Tool data for 3-D touch trigger probe (only when bit 1
is set in MP7411 = 1, also see the Touch Probe Cycles Manual)

Abbr.

Input

Dialog

TYPE

Tool type: Press the ASSIGN TYPE soft key (3rd soft-key row); the
TNC displays a pop-up window where you can select the type of
tool. Functions are currently only assigned to the DRILL and MILL
tool types.

Tool type?

TMAT

Tool material: Press the ASSIGN MATERIAL soft key (3rd soft-key
row): The TNC displays a pop-up window where you can select
the type of cutting material.

Tool material?

CDT

Cutting data table: Press the SELECT CDT soft key (3rd soft-key
row): The TNC displays a pop-up window where you can select a
cutting data table.

Name of cutting data table?

Abbr.

Input

Dialog

CAL-OF1

During calibration, the TNC stores in this column the center
misalignment in the reference axis of the 3-D probe, if a tool
number is indicated in the calibration menu.

Center misalignmt. in ref. axis?

CAL-OF2

During calibration, the TNC stores in this column the center
misalignment in the minor axis of the 3-D probe, if a tool number
is indicated in the calibration menu.

Center misalignment minor axis?

CAL-ANG

During calibration, the TNC stores in this column the spindle angle
at which the 3-D probe was calibrated, if a tool number is
indicated in the calibration menu.

Spindle angle for calibration?