beautypg.com

Activating/deactivating afc – HEIDENHAIN iTNC 530 (340 49x-04) User Manual

Page 702

background image

702

12 Test Run and Program Run

12.9 A

d

aptiv

e

F

e

ed Contr

o

l Sof

tw

a

re

Option (AFC)

Activating/deactivating AFC

Select the Program Run, Full Sequence mode of

operation.

Shift the soft-key row.

To activate the adaptive feed control: Set the soft key

to ON, and the TNC displays the AFC symbol in the
position display (see ““General” status display” on
page 55).

To deactivate the adaptive feed control: Set the soft

key to OFF.

The adaptive feed control remains active until you
deactivate it by soft key. The TNC remembers the setting
of the soft key even if the power is interrupted.

If the adaptive feed control is active in the control mode,
the TNC internally sets the spindle override to 100%. Then
you can no longer change the spindle speed.

If the adaptive feed control is active in the control mode,
the TNC takes over the feed rate override function:

„

If you increase the feed rate override, it has no influence
on the control.

„

If you decrease the feed rate override by more than 10%
with respect to the maximum setting, the TNC switches
the adaptive feed control off. In this case the TNC
displays a window to inform you.

The adaptive feed control is not active in NC blocks
containing FMAX.

Mid-program startup is allowed during active feed control
and the TNC takes the cut number of the startup point into
account.

In the additional status display, the TNC displays various
pieces of information when adaptive feed control is active
(see “Adaptive Feed Control (AFC tab, software option)”
on page 63).
In addition, the TNC shows the symbol

in

the position display.