beautypg.com

4 separate program as subprogram, Operating sequence, Programming notes – HEIDENHAIN iTNC 530 (340 49x-04) User Manual

Page 583

background image

HEIDENHAIN iTNC 530

583

1

0

.4 Separ

a

te

Pr

ogr

am as Subpr

ogr

am

10.4 Separate Program as

Subprogram

Operating sequence

1

The TNC executes the part program up to the block in which
another program is called with CALL PGM.

2

Then the other program is run from beginning to end.

3

The TNC then resumes the first (calling) part program with the
block after the program call.

Programming notes

„

No labels are needed to call any program as a subprogram.

„

The called program must not contain the miscellaneous functions
M2 or M30. If you have defined subprograms with labels in the
called program, you can then use M2 or M30 with the FN 9: IF +0
EQU +0 GOTO LBL 99

jump function to force a jump over this program

section.

„

The called program must not contain a CALL PGM call into the calling
program, otherwise an infinite loop will result.

0 BEGIN PGM A

CALL PGM B

END PGM A

0 BEGIN PGM B

END PGM B

1

3

2

S

R