HEIDENHAIN iTNC 530 (340 49x-04) - Manual (Page 17)

HEIDENHAIN iTNC 530 17
F
u
nctions c
h
ang
e
d in 340 49x
-0
1 since
the pr
edecessor v
e
rsions 340
422-xx/
340 423-xx
Changed functions with 340 49x-04
„ DCM: Retraction after collision simplified (see “Early warning
zone,” page 99)
„ The input range for polar angles was increased (see “Circular path
CP around pole CC” on page 263)
„ The value range for Q-parameter assignment was increased (see
“Programming notes,” page 597)
„ The pocket-, stud- and slot-milling cycles 210 to 214 were removed
from the standard soft-key row (CYCL DEF > POCKETS/STUDS/
SLOTS). For reasons of compatibility, the cycles will still be
available, and can be selected via the GOTO key.
„ The soft-key rows in the Test Run operating mode were modified to
those of the smarT.NC operating mode
„ Windows XP is now used on the dual-processor version (see
“Introduction” on page 768)
„ Conversion from FK to H was moved to the special functions (SPEC
FCT) (see “Converting FK programs into HEIDENHAIN
conversational format” on page 272)
„ Filtering of contours was moved to the special functions (SPEC FCT)
(see “Filtering Contours (FCL 2 Function)” on page 574)
„ Loading of values from the pocket calculator was changed (see “To
transfer the calculated value into the program,” on page 165)