beautypg.com

D data (cycle 30) – HEIDENHAIN iTNC 530 (340 49x-04) User Manual

Page 499

background image

HEIDENHAIN iTNC 530

499

8.1

1

Cy

cles f

o

r Multipass Milling

3-D DATA (Cycle 30)

1

From the current position, the TNC positions the tool at rapid
traverse FMAX in the tool axis to the set-up clearance above the
MAX point that you have programmed in the cycle.

2

The tool then moves at FMAX in the working plane to the MIN
point you have programmed in the cycle.

3

From this point, the tool advances to the first contour point at the
feed rate for plunging.

4

The TNC subsequently processes all points that are stored in the
digitizing data file at the feed rate for milling. If necessary, the
TNC retracts the tool between machining operations to the set-up
clearance

if specific areas are to be left unmachined.

5

At the end of the cycle, the tool is retracted at FMAX to the set-up
clearance.

PGM name 3-D data:

Enter the name of the program in

which the contour data is stored. If the file is not
stored in the current directory, enter the complete
path.

Min. point of range:

Lowest coordinates (X, Y and Z

coordinates) in the range to be milled.

Max. point of range:

Largest coordinates (X, Y and Z

coordinates) in the range to be milled.

Set-up clearance

1

(incremental value): Distance

between tool tip and workpiece surface for tool
movements in rapid traverse.

Plunging depth

2

(incremental value): Infeed per cut.

Feed rate for plunging

3

: Traversing speed of the

tool in mm/min during penetration.

Feed rate for milling

4

: Traversing speed of the tool

in mm/min while milling.

Miscellaneous function M:

Optional entry of a

miscellaneous function, for example M13.

Example: NC blocks

64 CYCL DEF 30.0 RUN 3-D DATA

65 CYCL DEF 30.1 PGM DIGIT.: BSP.H

66 CYCL DEF 30.2 X+0 Y+0 Z-20

67 CYCL DEF 30.3 X+100 Y+100 Z+0

68 CYCL DEF 30.4 SETUP 2

69 CYCL DEF 30.5 PECKG +5 F100

70 CYCL DEF 30.6 F350 M8

4

Y

X

MIN

MAX

X

Z

1

2

3

Before programming, note the following

You can use Cycle 30 to run conversational programs
created offline in multiple infeeds.