beautypg.com

12 coor dinat e t ransf or mation cy cles – HEIDENHAIN iTNC 530 (340 49x-04) User Manual

Page 530

background image

530

8 Programming: Cycles

8.12 Coor

dinat

e

T

ransf

or

mation Cy

cles

5 Set the datum

„

Manually by touching the workpiece with the tool in the untilted
coordinate system (see “Datum Setting (Without a 3-D Touch
Probe),” page 82).

„

Controlled with a HEIDENHAIN 3-D touch probe (see the Touch
Probe Cycles Manual, chapter 2).

„

Automatically by using a HEIDENHAIN 3-D touch probe (see the
Touch Probe Cycles Manual, chapter 3).

6 Start the part program in the operating mode Program Run, Full
Sequence

7 Manual Operation mode

Use the 3-D ROT soft key to set the TILT WORKING PLANE function
to INACTIVE. Enter an angular value of 0° for each axis in the menu
(see “Activating manual tilting,” page 95).