HEIDENHAIN iTNC 530 (340 49x-04) - Manual (Page 13)

HEIDENHAIN iTNC 530 13
TNC Model, Sof
tw
a
re
and F
eat
ur
es
New functions with 340 49x-04
„ The global parameter settings function makes it possible to activate
handwheel superimposed traverse in the active tool axis direction
(virtual axis) (see “Virtual axis VT” on page 694)
„ Machining patterns can now easily be defined with PATTERN DEF
(see “Pattern Definition PATTERN DEF,” page 346)
„ Program defaults valid globally can now be defined for machining
cycles (see “Program Defaults for Machining Cycles,” page 342)
„ Now, in Cycle 209 TAPPING WITH CHIP BREAKING, you can define a
factor for the retraction shaft speed, so that you can depart the hole
faster (see “TAPPING WITH CHIP BREAKING (Cycle 209),” page
382)
„ In Cycle 22 ROUGH-OUT, you can now define the fine-roughing
strategy (see “ROUGH-OUT (Cycle 22),” page 456)
„ In the new Cycle 270 CONTOUR TRAIN DATA, you can define the type
of approach of Cycle 25 CONTOUR TRAIN (see “CONTOUR TRAIN
DATA (Cycle 270),” page 463)
„ New Q-parameter function for reading a system datum was
introduced (see “Copying system data to a string parameter,” page
640)
„ New functions for copying, moving and deleting files from within
the NC program were introduced (see “File Functions,” page 575)
„ DCM: Collision objects can now be shown three-dimensionally
during machining (see “Graphic depiction of the protected space
(FCL4 function),” page 101)
„ DXF converter: New settings possibility introduced, with which the
TNC automatically selects the circle center when loading points
from circular elements (see “Basic settings,” page 290)
„ DXF converter: Element information is shown in an additional info
window (see “Selecting and saving a contour,” page 295)
„ AFC: A line diagram is now shown in the additional AFC status
display (see “Adaptive Feed Control (AFC tab, software option)” on
page 63)
„ AFC: Control settings parameters selectable by machine tool builder
(see “Adaptive Feed Control Software Option (AFC)” on page 695)
„ AFC: The spindle reference load currently being taught is shown in
a pop-up window in the teach-in mode. In addition, the learning
phase can be restarted at any time via soft key (see “Recording a
teach-in cut” on page 699).
„ AFC: The dependent file .H.AFC.DEP can now also be
modified in the Programming and Editing operating mode (see
“Recording a teach-in cut” on page 699)
„ The maximum path permitted for LIFTOFF was increased to 30 mm
(see “Automatically retract tool from the contour at an NC stop:
M148” on page 321)
„ File management was adapted to the file management of smarT.NC
(see “Overview: Functions of the file manager” on page 118)
„ New function for generating service files was introduced (see
“Generating service files” on page 170)
„ A window manager was introduced (see “Window Manager” on
page 64)
„ The new dialog languages Turkish and Romanian were introduced
(software option, Page 745)