Contour train data (cycle 270), 8 sl c y cles – HEIDENHAIN iTNC 530 (340 49x-04) User Manual
Page 463

HEIDENHAIN iTNC 530
463
8.8 SL c
y
cles
CONTOUR TRAIN DATA (Cycle 270)
If desired, you can use this cycle to specify various properties of
Cycle 25, CONTOUR TRAIN.
Type of approach/departure
Q390: Definition of the
type of approach or departure.
Q390 = 0:
Approach the contour tangentially on a circular arc.
Q390 = 1:
Approach the contour tangentially on a straight line.
Q390 = 2:
Approach the contour at a right angle.
Radius comp. (0=R0/1=RL/2=RR)?
Q391: Definition of
the radius compensation:
Q391 = 0:
Machine the defined contour without radius
compensation
Q391 = 1:
Machine the defined contour with compensation to
the left
Q391 = 2:
Machine the defined contour with compensation to
the right
Approach/departure radius
Q392: Only in effect if
tangential approach on a circular path was selected.
Radius of the approach/departure arc.
Center angle
Q393: Only in effect if tangential
approach on a circular path was selected. Angular
length of the approach arc.
Distance to auxiliary point
Q394: Only in effect if
tangential approach on a straight line or right-angle
approach was selected. Distance to the auxiliary point
from which the TNC is to approach the contour.
Example: NC blocks
62 CYCL DEF 25 CONTOUR TRAIN DATA
Q390=0
;TYPE OF APPROACH
Q391=1
;RADIUS COMPENSATION
Q392=3
;RADIUS
Q393=+45
;CENTER ANGLE
Q394=+2
;DISTANCE
Before programming, note the following
Cycle 270 is DEF active which means that it becomes
effective as soon as it is defined in the part program.
If Cycle 270 is used, do not define any radius
compensation in the contour subprogram.
Approach and departure properties are always performed
identically (symmetrically) by the TNC.
Define Cycle 270 before Cycle 25.