HEIDENHAIN iTNC 530 (340 49x-04) - Manual (Page 191)

HEIDENHAIN iTNC 530 191
4.15 P
a
llet Oper
ation with T
ool-Or
ient
e
d Mac
h
ining
Setting up details in the workpiece level
„ Workpiece: The number of the workpiece is displayed. The number
of workpieces within this fixture or pallet level is shown after the
slash.
„ Datum: Enter the workpiece datum.
„ Datum table: Enter the name and path of the datum table valid for
machining the workpiece. If you use the same datum table for all
workpieces, enter the name and path in the pallet or fixture levels.
The data is automatically transferred to the workpiece level.
„ NC program: Enter the path of the NC program that is necessary for
machining the workpiece.
„ Safe height (optional): Safe position for the individual axes
referenced to the workpiece. The positions entered are only
approached if these values were read and correspondingly
programmed in the NC macros.