HEIDENHAIN iTNC 530 (340 49x-04) - Manual (Page 53)

HEIDENHAIN iTNC 530 53
1
.3 Modes of Oper
ation
Programming and Editing
In this mode of operation you can write your part programs. The FK
free programming feature, the various cycles and the Q parameter
functions help you with programming and add necessary information.
If desired, the programming graphics or the 3-D line graphics (FCL 2
function) display the programmed traverse paths.
Soft keys for selecting the screen layout
Test Run
In the Test Run mode of operation, the TNC checks programs and
program sections for errors, such as geometrical incompatibilities,
missing or incorrect data within the program or violations of the work
space. This simulation is supported graphically in different display
modes.
Soft keys for selecting the screen layout: see “Program Run, Full
Sequence and Program Run, Single Block,” page 54.
Window Soft key
Program blocks
Left: program blocks, right: program structure
Left: program blocks, right: graphics
Left: program blocks, right: 3-D line graphics