beautypg.com

8 a d ditional f unctions – HEIDENHAIN iTNC 530 (340 49x-04) User Manual

Page 620

background image

620

11 Programming: Q Parameters

1

1

.8 A

d

ditional F

unctions

10

-

Feed rate for milling in active fixed cycle

11

-

Direction of rotation for active fixed cycle

12

-

Dwell time for active fixed cycle

13

-

Thread pitch for Cycles 17, 18

14

-

Milling allowance for active fixed cycle

15

-

Direction angle for rough out in active fixed cycle

Data from the tool table, 50

1

Tool no.

Tool length

2

Tool no.

Tool radius

3

Tool no.

Tool radius R2

4

Tool no.

Oversize in tool length DL

5

Tool no.

Oversize in tool radius DR

6

Tool no.

Oversize for tool radius DR2

7

Tool no.

Tool inhibited (0 or 1)

8

Tool no.

Number of the replacement tool

9

Tool no.

Maximum tool age TIME1

10

Tool no.

Maximum tool age TIME2

11

Tool no.

Current tool age CUR. TIME

12

Tool no.

PLC status

13

Tool no.

Maximum tooth length LCUTS

14

Tool no.

Maximum plunge angle ANGLE

15

Tool no.

TT: Number of teeth CUT

16

Tool no.

TT: Wear tolerance in length LTOL

17

Tool no.

TT: Wear tolerance in radius RTOL

18

Tool no.

TT: Rotational direction DIRECT (0=positive/
-1=negative)

19

Tool no.

TT: Offset in plane R-OFFS

20

Tool no.

TT: Offset in length L-OFFS

21

Tool no.

TT: Break tolerance for length LBREAK

22

Tool no.

TT: Break tolerance in radius RBREAK

23

Tool no.

PLC value

Group name, ID number

Number

Index

Meaning