beautypg.com

Scaling factor (cycle 11), 12 coor dinat e t ransf or mation cy cles – HEIDENHAIN iTNC 530 (340 49x-04) User Manual

Page 523

background image

HEIDENHAIN iTNC 530

523

8.12 Coor

dinat

e

T

ransf

or

mation Cy

cles

SCALING FACTOR (Cycle 11)

The TNC can increase or reduce the size of contours within a program,
enabling you to program shrinkage and oversize allowances.

Effect

The SCALING FACTOR becomes effective as soon as it is defined in
the program. It is also effective in the Positioning with MDI mode of
operation. The active scaling factor is shown in the additional status
display.

The scaling factor has an effect on

„

the working plane, or on all three coordinate axes at the same time
(depending on MP 7410)

„

dimensions in cycles

„

the parallel axes U,V,W

Prerequisite

It is advisable to set the datum to an edge or a corner of the contour
before enlarging or reducing the contour.

Scaling factor?:

Enter the scaling factor SCL. The

TNC multiplies the coordinates and radii by the SCL
factor (as described under “Effect” above).

Enlargement: SCL greater than 1 (up to 99.999 999)

Reduction: SCL less than 1 (down to 0.000 001)

Cancellation

Program the SCALING FACTOR cycle once again with a scaling factor
of 1.

Example: NC blocks

11 CALL LBL 1

12 CYCL DEF 7.0 DATUM SHIFT

13 CYCL DEF 7.1 X+60

14 CYCL DEF 7.2 Y+40

15 CYCL DEF 11.0 SCALING

16 CYCL DEF 11.1 SCL 0.75

17 CALL LBL 1

Z

Z

X

X

Y

Y

X

Y

60

40

X

Y

36

30

(27)

(22.5)