8 adding comments, Function, Entering comments during programming – HEIDENHAIN iTNC 530 (340 49x-04) User Manual
Page 158: Inserting comments after program entry, Entering a comment in a separate block, 8 a dding comments 4.8 adding comments

158
4 Programming: Fundamentals of NC, File Management, Programming Aids, Pallet Management
4.8 A
dding Comments
4.8 Adding Comments
Function
You can add comments to any desired block in the part program to
explain program steps or make general notes.
There are three possibilities for adding comments:
Entering comments during programming
Enter the data for a program block, then press the semicolon key “;”
on the alphabetic keyboard—the TNC displays the dialog prompt
COMMENT ?
Enter your comment and conclude the block by pressing the END
key.
Inserting comments after program entry
Select the block to which a comment is to be added.
Select the last word in the block with the right arrow key: A
semicolon appears at the end of the block and the TNC displays the
dialog prompt COMMENT ?
Enter your comment and conclude the block by pressing the END
key.
Entering a comment in a separate block
Select the block after which the comment is to be inserted.
Initiate the programming dialog with the semicolon key (;) on the
alphabetic keyboard.
Enter your comment and conclude the block by pressing the END
key.
If the TNC cannot show the entire comment on the
screen, the >> sign is displayed.