HEIDENHAIN iTNC 530 (340 49x-04) - Manual (Page 688)

688 12 Test Run and Program Run
12.8 Global Pr
ogr
a
m Set
tings (Sof
tw
ar
e Option)
12.8 Global Program Settings
(Software Option)
Function
The global program settings, which are used in particular for large
molds and dies, are available in the Program Run mode and MDI
mode. You can use them to define various coordinate transformations
and settings that are globally effective and are superimposed on the
respectively selected NC program so that you do not need to edit the
NC program.
You can activate and deactivate global program settings, even in mid-
program if you have interrupted the program run (see “Interrupting
machining” on page 676).
The following global program settings are available:
Functions Icon Page
Swapping axes Page 691
Basic rotation Page 691
Additional, additive datum shift Page 692
Superimposed mirroring Page 692
Superimposed rotation Page 693
Axis locking Page 693
Definition of a handwheel
superimposition, even in the virtual axis
direction Page 694
Definition of a globally effective feed rate
factor Page 693