Amer Networks E5 CLI - Manual (Page 64)

pcapdump -cleanup
Remove all captured packets, release capture mode and delete all written capture files from disk.
Options
-cleanup Remove all captured packets, release capture
mode and delete all written capture files from disk.
-count= Number of packets to capture.
-destport=<0...65535> Destination TCP/UDP port filter.
-eth= Ethernet address filter.
-ethdest= Ethernet destination address filter.
-ethsrc= Ethernet source address filter.
-filename= Filename for capture file.
-icmp ICMP filter.
-ip= IP address filter.
-ipdest= Destination IP address filter.
-ipsrc= Source IP address filter.
-ipversion=<1...15> IP version filter.
-out Realtime packet brief dumped to console.
-out-nocap Unbuffered (not stored in memory) realtime packet
brief dumped to console.
-port=<0...65535> TCP/UDP port filter.
-promisc Set iface in promiscuous mode.
-proto=<0...255> IP protocol filter.
-show Show a captured packets brief.
-size= Size (kb) of buffer to store captured packets in
memory (default 512kb).
-snaplen= Maximum length of each packet to capture.
-srcport=<0...65535> Source TCP/UDP port filter.
-start Start capture.
-status Show capture status.
-stop Stop capture.
-tcp TCP filter.
-udp UDP filter.
-wipe Remove all captured packets from memory.
Chapter 2: Command Reference
64