Highavailability – Amer Networks E5 CLI User Manual
Page 157
3.42. HighAvailability
Description
Configure the High Availability cluster parameters for this system.
Properties
Enabled
Enable high availability. (Default: No)
Sync
Specifies if cluster members are to synchronization
configuration data. (Default: Yes)
ClusterID
A (locally) unique cluster ID to use in identifying
this group of HA security gateways. (Default: 0)
SyncIface
Specifies
the
interface
used
for
state
synchronization.
NodeID
Master or Slave. (Default: Master)
HASyncBufSize
How much sync data, in KB, to buffer while waiting
for acknowledgments from the cluster peer.
(Default: 1024)
HASyncMaxPktBurst
The maximum number of state sync packets to
send in a burst. (Default: 20)
HAInitialSilence
The number of seconds to stay silent on startup or
after reconfiguration. (Default: 5)
UseUniqueSharedMac
Use a unique shared mac address for each
interface. (Default: Yes)
HADeactivateBeforeReconf
Deactivate(hand over) before Reconfiguration if
Active. (Default: Yes)
ReconfFailoverTime
Number of non-responsive seconds before failover
at HA reconf (0=immediate failover). (Default: 0)
HAFailoverTime
Number of milliseconds before failover when
active HA node becomes non-responsive. (Default:
750)
Note
This object type does not have an identifier and is identified by the name of the type
only. There can only be one instance of this type.
Chapter 3: Configuration Reference
157