Amer Networks E5 CLI - Manual (Page 193)

3.66. L2TPClient
Description
A PPTP/L2TP client interface is a PPP (Point-to-Point Protocol) tunnel over an existing IP network.
Its IP address and DNS servers are dynamically assigned.
Properties
Name Specifies a symbolic name for the interface.
(Identifier)
IP The host name to store the assigned IP address in,
if this network object exists and have a value other
then 0.0.0.0 the PPTP/L2TP client will try to get that
one from the PPTP/L2TP server as preferred IP.
(Optional)
Network The network from which traffic should be routed
into the tunnel.
RemoteEndpoint The IP address of the L2TP/PPTP server.
TunnelProtocol Specifies if PPTP or L2TP should be used for this
tunnel. (Default: PPTP)
OriginatorIPType Specifies what IP address to use as source IP in e.g.
NAT. (Default: LocalInterface)
OriginatorIP Manually specified originator IP address to use as
source IP in e.g. NAT.
DNS1 IP of the primary DNS server. (Optional)
DNS2 IP of the secondary DNS server. (Optional)
Username Specifies the username to use for this PPTP/L2TP
interface.
Password The password to use for this PPTP/L2TP interface.
PPPAuthNoAuth Allow no authentication for this tunnel. (Default:
No)
PPPAuthPAP Use PAP authentication protocol for this tunnel.
User name and password are sent in plaintext.
(Default: Yes)
PPPAuthCHAP Use CHAP authentication protocol for this tunnel.
(Default: Yes)
PPPAuthMSCHAP Use MS-CHAP authentication protocol for this
tunnel. (Default: Yes)
PPPAuthMSCHAPv2 Use MS-CHAP v2 authentication protocol for this
tunnel. (Default: Yes)
MPPENone Allow authentication without Microsoft
Point-to-Point Encryption (MPPE). (Default: Yes)
Chapter 3: Configuration Reference
193