Amer Networks E5 CLI User Manual
Page 194
MPPERC440
Use an RC4 40 bit MPPE session key with MS-CHAP
or MS-CHAP v2 authentication protocol. (Default:
Yes)
MPPERC456
Use an RC4 56 bit MPPE session key with MS-CHAP
or MS-CHAP v2 authentication protocol. (Default:
Yes)
MPPERC4128
Use an RC4 128 bit MPPE session key with
MS-CHAP or MS-CHAP v2 authentication protocol.
(Default: Yes)
DialOnDemand
Enable Dial-on-demand which means that the
L2TP/PPTP tunnel will not be setup until traffic is
sent on the interface. (Default: No)
ActivitySensing
Specifies if the dial-on-demand should trigger on
inbound or outbound traffic or both. (Default:
BiDirectional)
IdleTimeout
Idle timeout in seconds for dial-on-demand.
(Default: 3600)
Metric
Specifies the metric for the auto-created route.
(Default: 90)
MTU
Specifies the size (in bytes) of the largest packet
that can be passed onward. (Default: 1456)
AutoInterfaceNetworkRoute
Automatically add a route for this interface using
the given remote network. (Default: Yes)
MPPEAllowStateful
Allow usage of Stateful MPPE (less secure, use only
for compatibility). (Default: No)
IPsecInterface
Use this IPsec interface to encypt the traffic to the
L2TP server. (L2TP/IPsec). (Optional)
MemberOfRoutingTable
All or Specific. (Default: All)
RoutingTable
Specifies the PBR table to insert the interface IP
route into. It also means that the specified routing
table will be used for all routing lookups, unless
overridden by a PBR rule. (Default: main)
Comments
Text describing the current object. (Optional)
Chapter 3: Configuration Reference
194