Amer Networks E5 CLI - Manual (Page 147)

3.35. Ethernet
Description
An Ethernet interface represents a logical endpoint for Ethernet traffic.
Properties
Name Specifies a symbolic name for the interface.
(Identifier)
EthernetDevice Hardware settings for the Ethernet interface.
VLanQoSInherit Set whether VLANs using the interface should
inherit the IP QoS bits. (Default: No)
ReceiveMulticastTraffic Sets the multicast receive mode of the interface.
(Default: Auto)
LACPPortPriority Port priority value to be sent in LACP messages.
(Default: 1)
IP The IP address of the interface.
Network The network of the interface.
DefaultGateway The default gateway of the interface. (Optional)
Broadcast The broadcast address of the connected network.
(Optional)
EnableIPv6 Enable processing of IPv6 traffic on this interface.
(Default: No)
IPv6IP The IP address of the interface.
IPv6Network The network of the interface.
IPv6DefaultGateway The default gateway of the interface. (Optional)
PrivateIP The private IP address of this high availability node.
(Optional)
NOCHB This will disable sending Cluster Heartbeats from
this interface (used by HA to detect if a node is
online and working). (Optional)
MTU Specifies the size (in bytes) of the largest packet
that can be passed onward. Must be 1294 or larger
when IPv6 is enabled. (Default: 1500)
Metric Specifies the metric for the auto-created route.
(Default: 100)
DHCPEnabled Enable DHCP client on this interface. (Default: No)
DHCPHostName Optional DHCP Host Name. Leave blank to use
default name. (Optional)
AutoSwitchRoute Enable transparent mode, which means that a
Chapter 3: Configuration Reference
147