Amer Networks E5 CLI - Manual (Page 172)

3.55. IPPolicy
Description
An IP Policy specifies what action to perform on network traffic that matches the specified filter
criteria.
Properties
Index The index of the object, starting at 1. (Identifier)
Name Specifies a symbolic name for the policy.
Action Allow or Deny. (Default: Allow)
SourceInterface Specifies the name of the receiving interface to be
compared to the received packet.
DestinationInterface Specifies the the destination interface to be
compared to the received packet.
SourceNetwork Specifies the sender span of IP addresses to be
compared to the received packet.
DestinationNetwork Specifies the span of IP addresses to be compared
to the destination IP of the received packet.
Service Specifies a service that will be used as a filter
parameter when matching traffic with this rule.
Schedule By adding a schedule to a rule, the security
gateway will only allow that rule to trigger at those
designated times. (Optional)
SourceAddressTranslation Action to take on source address. (Default: Auto)
NATSourceAddressAction Specify method to determine which sender
address to use. (Default: OutgoingInterfaceIP)
SATSourceAddressAction Specify method to determine which sender
address to use.
SourceNewIP Specifies which sender address will be used.
SourceBaseIP Specifies base address for sender address.
SourceNATPool Specifies NAT Pool to fetch sender address to be
used.
SourcePortAction Specify method to determine which port action to
use. (Default: None)
SourceNewSinglePort Translate to this port. (Optional)
SourceBasePort Transpose using as base this port. (Optional)
DestAddressTranslation Action to take on destination address. (Default:
None)
DestAddressAction Specify method to determine which destination
Chapter 3: Configuration Reference
172