Amer Networks E5 CLI - Manual (Page 156)

3.41. GRETunnel
Description
A GRE interface is a Generic Routing Encapsulation (no encryption, no authentication, only
encapsulation) tunnel over an existing IP network.
Properties
Name Specifies a symbolic name for the interface.
(Identifier)
IP Specifies the IP address of the GRE interface.
Network Specifies the network address of the GRE interface.
RemoteEndpoint Specifies the IP address of the remote endpoint.
EncapsulationChecksum Add an extra level of checksum above the one
provided by the IPv4 layer. (Default: No)
OriginatorIPType Specifies what IP address to use as source IP in e.g.
NAT. (Default: LocalInterface)
OriginatorIP Manually specified originator IP address to use as
source IP in e.g. NAT.
Metric Specifies the metric for the auto-created route.
(Default: 90)
AutoInterfaceNetworkRoute Automatically add a route for this interface using
the given remote network. (Default: Yes)
OuterPBRTable The outer PBR Table to use. (Default: main)
UseSessionKey Specify whether or not to use a session key.
(Default: No)
SessionKey Session key. (Default: 0)
MemberOfRoutingTable All or Specific. (Default: All)
RoutingTable Specifies the PBR table to insert the interface IP
route into. It also means that the specified routing
table will be used for all routing lookups, unless
overridden by a PBR rule. (Default: main)
Comments Text describing the current object. (Optional)
Chapter 3: Configuration Reference
156