Amer Networks E5 CLI - Manual (Page 220)

StubMetric Route metric for stub area. (Optional)
FilterExternal Specifies the network addresses allowed to be
imported into this area from external routing
sources. (Optional)
FilterInterArea Specifies the network addresses allowed to be
imported from other routers inside the area.
(Optional)
Comments Text describing the current object. (Optional)
3.87.1.1. OSPFInterface
Description
Select and define the properties of an interface that should be made a member of the Router
Process.
Properties
Interface Specifies which interface in the security gateway
will be used for this OSPF interface. (Identifier)
Type Auto, Broadcast, Point-to-point or
Point-to-multipoint. (Default: Auto)
Network Specifies the network related to the configured
OSPF interface. (Optional)
MetricType Metric value or Bandwidth. (Default: MetricValue)
Metric Specifies the routing metric for this OSPF interface.
(Default: 10)
BandwidthValue Specifies the bandwidth for this OSPF interface.
BandwidthUnit Specifies the bandwidth unit. (Default: Mbps)
UseDefaultAuth Use the authentication configuration specified in
the OSPF process. (Default: Yes)
AuthType Specifies the authentication type for the OSPF
protocol exchanges. (Default: None)
AuthPassphrase Specifies the passphrase used for authentication.
(Optional)
AuthMD5ID Specifies the MD5 key ID used for MD5 digest
authentication.
AuthMD5Key A 128-bit key used to produce the MD5 digest.
(Optional)
HelloInterval Specifies the number of seconds between HELLO
packets sent from the interface. (Default: 10)
RtrDeadInterval If no HELLO packets are received from a neighbor
within this interval (in seconds), that neighbor
Chapter 3: Configuration Reference
220