beautypg.com

Ospfneighbor, Ospfaggregate – Amer Networks E5 CLI User Manual

Page 221

background image

router will be declared to be down. (Default: 40)

RxmtInterval

Specifies

the

number

of

seconds

between

retransmissions of LSAs to neighbors on this
interface. (Default: 5)

RtrPrio

Specifies the router priority, a higher number
increases this routers chance of becoming DR or
BDR, if 0 is specified this router will not be eligible
in the DR/BDR election. (Default: 1)

InfTransDelay

Specifies the estimated transmit delay for the
interface in seconds. This value represents the
maximum time it takes to forward a LSA packet
trough the router. (Default: 1)

WaitInterval

Specifies the number of seconds between the time
when the interface brought up and the election of
the DR and BDR. This value should be higher than
the hello interval. (Default: 40)

Passive

Enable to make it possible to include networks into
the OSPF routing process, without running OSPF
on the interface connected to that network.
(Default: No)

IgnoreMTU

Enable to allow OSPF MTU mismatches. (Default:
No)

Comments

Text describing the current object. (Optional)

3.87.1.2. OSPFNeighbor

Description

For point-to-point and point-to-multipoint networks, specify the IP addresses of directly
connected routers.

Properties

Interface

Specifies the OSPF interface of the neighbor.

IPAddress

IP Address of the neighbor.

Metric

Specifies the metric of the neighbor. (Optional)

Comments

Text describing the current object. (Optional)

Note

If no

Index

is specified when creating an instance of this type, the object will be placed

last in the list and the

Index

will be equal to the length of the list.

3.87.1.3. OSPFAggregate

Chapter 3: Configuration Reference

221

This manual is related to the following products: