Amer Networks E5 CLI User Manual
Page 279
HTTPBanners
HTTP Authentication HTML Banners. (Default:
Default)
RealmString
The string that is presented as a part of the 401 -
Authentication Required message. (Optional)
HostCertificate
Specifies the host certificate that the security
gateway sends to the client. Only RSA certificates
are supported.
RootCertificate
Specifies the root certificate that was used to sign
the host certificate. Only RSA certificates are
supported. (Optional)
PPPAuthNoAuth
Allow no authentication. (Default: No)
PPPAuthPAP
Use PAP authentication protocol. User name and
password are sent in plaintext. (Default: Yes)
PPPAuthCHAP
Use CHAP authentication protocol. (Default: Yes)
PPPAuthMSCHAP
Use MS-CHAP authentication protocol. (Default:
Yes)
PPPAuthMSCHAPv2
Use MS-CHAP v2 authentication protocol. (Default:
Yes)
IdleTimeout
A successfully authenticated user will be logged
out automatically after this many seconds, if no
traffic has been received from the user's IP address.
(Default: 1800)
SessionTimeout
A successfully authenticated user will be logged
out automatically after this many seconds, even if
traffic has been received from the user's IP address.
(Optional)
UseServerTimeouts
Use timeouts received from the authentication
server. If no values are received, the manually
specified values will be used. (Default: No)
MultipleUsernameLogins
Specifies how multiple username logins will be
handled. (Default: AllowMultiple)
ReplaceIdleTime
Replace existing user if idle for more than this
number of seconds. (Default: 10)
AccountingServers
Specifies the accounting servers that will be used
to report user usage matching this rule. (Optional)
PrimaryRetryIntervalAcc
How many seconds to wait before trying to use the
primary server again if it has failed. (Default: 0)
BytesSent
Enable reporting of the number of bytes sent by
the user. (Default: Yes)
PacketsSent
Enable reporting of the number of packets sent by
the user. (Default: Yes)
BytesReceived
Enable reporting of the number of bytes received
by the user. (Default: Yes)
Chapter 3: Configuration Reference
279