Amer Networks E5 CLI - Manual (Page 198)

3.69. L2TPv3Server
Description
A L2TPv3 server interface terminates L2 (Ethernet and VLAN) tunnels set up over existing IP
networks.
Properties
Name Specifies a symbolic name for the interface.
(Identifier)
IP The IP address of the L2TPv3 Server interface.
LocalNetwork The network on "this side" of the L2TPv3 tunnel.
Protocol Specifies if L2TPv3 should tunnel over IP or UDP.
(Default: UDP)
Interface The interface that the L2TPv3 Server should be
listening on.
ServerIP Specifies the IP that the L2TPv3 Server should
listen on, this can be an IP of a interface, or for
example an ARP published IP.
AutoRouteMetric Specifies the metric for the auto-created route
used by the L2TPv3 Server. (Default: 100)
HostName The host name for this L2TPv3 Server. (Used in the
Host Name AVP). (Optional)
RouterID Router ID. (Used in the Router ID AVP). (Optional)
MemberOfRoutingTable All or Specific. (Default: All)
RoutingTable Specifies the PBR table to insert the interface IP
route into. It also means that the specified routing
table will be used for all routing lookups, unless
overridden by a PBR rule. (Default: main)
ProxyARPAllInterfaces Always select all interfaces, including new ones, for
publishing routes via Proxy ARP. (Default: No)
ProxyARPInterfaces Specifies the interfaces on which the security
gateway should publish routes via Proxy ARP.
(Optional)
Comments Text describing the current object. (Optional)
Chapter 3: Configuration Reference
198