Welltech Dialogic SS7 Protocols ISUP - Manual (Page 49)

Dialogic ® SS7 Protocols ISUP Programmer's Manual Issue 15
49
The following optional parameters are supported in ANSI mode only:
• Business group
• Carrier identification
• Carrier selection information
• Charge number
• Circuit assignment map
• Egress service
• Generic name
• Information request indicators
• Jurisdiction
• Network transport
• Operator services information
• Originating line information
• Precedence
• Service code indicator
• Special processing request
• Transaction request
6.5.29 Setup Response
This primitive is used by the application to answer an incoming call. There
are two forms of the primitive. In ITU-T mode, one form is used before an
Address Complete message has been issued and the other after an Address
Complete message has been issued. In ANSI mode, a single primitive is used
both before and after Address Complete.
Before ACM Issued
Note: This message is only applicable to ITU-T operation.
Message type
CON (Connect Message)
Mandatory parameters
None
Optional parameters
• Application transport
• Access delivery information
• Access transport