13 read circuit group data request, Read circuit group data request – Welltech Dialogic SS7 Protocols ISUP User Manual
Page 150

Section 8 Non-Primitive Interface
150
Value
State
Outgoing call states:
0x86
outgoing call – waiting for RLC
0x87
outgoing call – waiting for Release confirmation from application
0x88
outgoing call – waiting for Reset response from application
0x89
outgoing call – waiting for Release request from application
0x8a
outgoing call – overload
Outgoing continuity test call states:
0xe0
outgoing continuity test call – idle
0xe1
outgoing continuity test call – waiting for timeout (before new continuity test call is
initiated)
0xe2
outgoing continuity test call – waiting for backward check tone
0xe3
outgoing continuity test call – waiting for RLC
0xe4
outgoing continuity test call – waiting for LPA
8.13
Read Circuit Group Data Request
This message requests the data for a specified circuit group. The data will be
given in the confirmation message and will be of exactly the same format as
the Configure Circuit Group Request (ISP_MSG_CNF_GRP). Refer to
Section
:
8.2 Configure Circuit Group Request on page 126
for details.
Read Request to ISUP
structure
MSG
type
ISP_MSG_R_GRP_DATA (0x6717)
id
gid
src
originating module ID
dst
ISUP module ID
rsp_req
Sending layer's bit set
hclass
0x00
status
0x00
err_info
0x00
len
See
8.2 Configure Circuit Group Request on page 126
for details.
Parameters
See
8.2 Configure Circuit Group Request on page 126
for details.
ISUP Response
method
by sending a MSG
type
0x2717
SUCCESS
ISP_BAD_ID
ISP_BAD_PARAM
status
ISP_BAD_MSG