Welltech Dialogic SS7 Protocols ISUP - Manual (Page 164)

Section 8 Non-Primitive Interface
164
Parameter Status Mnemonic id
1 2
Description
16 0x10 ISPe_APM_LOW 0 0 0 A message has been received
from MTP/M3UA with an APP
parameter indicating new but not
last segment, and the module is
running short of internal APM
structures. This is a warning
only; the module is still behaving
correctly.
17 0x11 ISPe_NO_APM 0 0 0 A message has been received
from MTP/M3UA with an APP
parameter indicating new but not
last segment, and the module
has exhausted all internal APM
structures.
Call states
For error indications with status ISPe_UMSG_UNEXPECTED, (0x0f), the valid
call states that may be reported are listed in the table below:
Call State Description
0x40 Idle
0x41 Outgoing call set-up
0x42 Incoming call set-up
0x43 Call connected
0x44 Waiting for the application to release
0x45 Locally autoblocked
0x46 Awaiting REL (from CPC)
0x47 Waiting RLC (from CPC)
0x48 Awaiting local reset complete
0x49 Overload
0x4a Wait for user to release and reset complete
0x4b Overload – RLC received from user
0x4c Waiting for continuity recheck
0x4d Incoming circuit seized
0x4e Outgoing circuit seized
0x4f Overload (incoming calls)