Welltech Dialogic SS7 Protocols ISUP - Manual (Page 47)

Dialogic ® SS7 Protocols ISUP Programmer's Manual Issue 15
47
Optional parameters
• Access transport
• Calling party's category
Defaults to 0x0a if not supplied
• Call reference
• Calling party number
• Forward call indicators
Defaults to 0x0040 if not supplied
• Generic digits
This parameter may be repeated (see Appendix E: ISUP Repeat
Parameters on page 197 ).
• Generic number (address)
This parameter may be repeated (see Appendix E: ISUP Repeat
Parameters ). on page 197
• Hop counter
• Nature of connection indicators
Defaults to 0x00 if not supplied
• Original called number
• Redirecting number
• Redirection information
• Remote operations
• Service activation
• Transit network selection
• User service information
In ANSI mode, defaults to 0x80, 0x90 , 0xa2 CCITT coding standard
information transfer capability speech 64kbit/s circuit mode μ --law (layer
1 protocol)
• User service information prime
• User to user information
If no user to user indicators are provided, presence of user to user
information is considered as an implicit request of service 1.
The following optional parameters are supported in ITU-T mode only:
Application transport
• Backward GVNS
• Call diversion treatment indicators
• Call offering treatment indicator
• Called IN number
• CCSS