Welltech Dialogic SS7 Protocols ISUP - Manual (Page 116)

Section 7 Management Interface
116
ptype
The type of management primitive taken from the following table:
Value Name Function
0 Reset Reset circuit(s)
1 Stop Reset Abort reset operation
2 M-Block Maintenance block circuit(s)
3 M-Unblock Maintenance unblock circuit(s)
4 M-Stop Abort maintenance (un)blocking
5 H-Block Hardware block circuit(s)
6 H-Unblock Hardware unblock circuit(s)
7 H-Stop Abort hardware (un)blocking
14 Set-Ic-Active Set state of circuit(s) to incoming active
15 Set-Og-Active Set state of circuit(s) to outgoing active
cic_mask
A 32 bit mask indicating to which of the circuits in the circuit group the
message applies.
7.4 Circuit Group Supervision Control Indication
This message is issued by ISUP to indicate completion of a circuit group
supervision control function which was initiated by message(s) received from
the remote signaling point.
Message Header
structure MSG
type ISP_MSG_CGSC_IND (0x0708)
id gid
src ISUP module ID
dst Management module ID
rsp_req 0x00
hclass 0x00
status 0x00
err_info 0x00
len 6
Parameter Area
offset 0, size 1 ptype Management primitive type.
offset 1, size 1 reserved Set to zero
parameters
offset 2, size 4 cic_mask Bits set to indicate affected circuits in group.