Welltech Dialogic SS7 Protocols ISUP - Manual (Page 125)

Dialogic ® SS7 Protocols ISUP Programmer's Manual Issue 15
125
sccp_id
Reserved for future use, this should always be set to zero.
maint_id
The default module id for the maintenance module used when the per-circuit
group maint_id is not specified in the circuit group configuration message.
timer_res
The number of system ticks between timer expiry messages being issued to
the ISUP module. This should usually be configured so that a timer expiry
message is sent to the ISUP module every 100ms.
num_tscan
The number of timer expiry messages received for each full scan of the
protocol timer table. This should usually be set to 10 so that each timer is
checked once per second (or every 10 timer expiry messages).
num_grps
The maximum number of circuit groups that will be used.
num_ccts
The maximum number of circuits that will be used.
max_sif
The maximum length Signaling Information Field permitted by the MTP. This
should either be set to 62 or 272 depending on the MTP capabilities.
sio
The default value to be used for the Service Indicator Octet in messages
issued to the MTP when the per-circuit group SIO is not specified in the circuit
group configuration message.
trace_id
Trace module id. Module id to which trace messages will be sent. If this
parameter is not supplied (set to zero) trace messages will be sent to the
management module id.
gap_msgs
Maximum number of pc status indication messages sent every gap_tim ticks.
If this parameter is not supplied (set to zero), maximum 5 messages will be
sent every ticks.
gap_tim
Number of ticks between gap_msgs messages.