Welltech Dialogic SS7 Protocols ISUP - Manual (Page 193)

Dialogic ® SS7 Protocols ISUP Programmer's Manual Issue 15
193
Appendix D: ISUP Configuration Option Settings
This section tabulates suggested circuit group option settings for various
different variants of ISUP. Please note that module options are not listed as
they are dependent upon the user application rather than the protocol variant
(refer to Section : 8.1 Configure Request on page 121 for further details).
For the suggested circuit group options in this section, the variant in the
Configure Circuit Group Request message should be set as follows:
Value of ‘variant’ field in the Configure Circuit Group
Request message 9
Variant (as indicated in the
option tables in this
appendix)
Value Mnemonic
2 ISPGVAR_ANSI ANSI
8 ISPGVAR_ANSI95
ETSI (V2 and V3) 1 ISPGVAR_ITU92
ITU Blue Book 0 ISPGVAR_BB
ITU (03/93 and later) 1 ISPGVAR_ITU92
Q.767 0 ISPGVAR_BB
The option value fields for the following options tables are described as
follows:
Option value Description
0 Option should not be set.
1 Option must be set.
>1 Option must be set (recommended value as indicated).
Options
Variant Bit Option
ANSI ETSI ITU Blue Book ITU Q.767
2 ISPGOP_ACM_CTRL 1 1 1 1 1
3 ISPGOP_ANM_CTRL 1 1 1 1 1
4 ISPGOP_SUS_CTRL 1 1 1 1 1
5 ISPGOP_RST_REQD 0 0 0 0 0
6 ISPGOP_REQ_CLI 0* 0* 0* 0* 0*
7 ISPGOP_EN_ST 0 0* 0* 0* 0*
8 ISPGOP_USR_SVC1 0 0* 0* 0* 0*
9 ISPGOP_USR_SVC2 0 0* 0* 0* 0*
10 ISPGOP_USR_SVC3 0 0* 0* 0* 0*
11 ISPGOP_COM 0 0 0 0 0
12 ISPGOP_T35 0 0* 0 0* 0*
9 See Configure Circuit Group Request on page 126 .