Welltech Dialogic SS7 Protocols ISUP - Manual (Page 163)

Dialogic ® SS7 Protocols ISUP Programmer's Manual Issue 15
163
The Software Event Code contained in the status field of the message
indicates the type of event. The following table lists the definition of each id
field and the parameter fields for each status.
The cic is the Circuit identification code and the cid is the circuit id.
Parameter Status Mnemonic id
1 2
Description
3 0x03 ISPe_ISPM_LOW 0 N/A N/A The internal pool of ISPM
message buffers is running short
of entries. If this fault persists,
contact support for assistance.
4 0x04 ISPe_NO_ISPM 0 N/A N/A The pool of ISPM message
buffers has been exhausted. If
this event occurs then correct
operation of the module is not
guaranteed.
5 0x05 ISPe_BAD_MSG message
type N/A N/A An unsupported (inter-module)
message type has been
received by the module.
6 0x06 ISPe_RECV_FAIL cic N/A N/A Format error in received protocol
message.
7 0x07 ISPe_TX_FMT_ERR message
type cid N/A Failure to format message for
transmission.
8 0x08 ISPe_TIM_START_ERR timer
identifier timer
reference cid An attempt was made to re-use
an active timer resource (timer
identifier).
9 0x09 ISPe_PAR_FMT_ERR parameter
name cid message
type
A parameter whose length is
outside the defined limits has
been received from the user.
10 0x0a ISPe_PAR_UNEXPECTED parameter
name cid message
type
A parameter which is either
unrecognized or not expected in
this primitive has been received
by ISUP from the user.
11 0x0b ISPe_MSG_UNRECOG message
type cid N/A A message which is
unrecognized has been received
from the user.
12 0x0c ISPe_BAD_FMT_LABEL 0 N/A N/A Bad label format received.
13 0x0d ISPe_MSG_FMT_ERR message
type cid N/A A badly formatted primitive has
been received from the user.
14 0x0e ISPe_WRONG_CID cid message
type N/A A primitive has been received
from the user for an unknown
circuit ID.
15 0x0f ISPe_UMSG_UNEXPECTED cid message
type state (see
following
‘Call state’
table) An unexpected message type
has been received from the
user.