Measurement Computing Personal Daq rev.6.0 - Manual (Page 78)

4-36 Personal DaqView 989394 Personal Daq User’s Manual
Note: When a chart contains overlapping channels and the channels share values such that their
traces reside on top of each other, then the channels that are listed lower in the display
list (the most recently added channels) will obscure the channels higher in the list (those which
were added first).
9. In the display area (on the left-hand side of the screen) click on a channel to check the channel’s
configuration and to re-configure the channel, if desired. The Display Configuration Setup Window
will appear similar to that in the following figure.
Note: Changing the display configuration does not change the existing channel configuration setup. It
only changes how the chart groups, charts, and channels will be displayed.
The following figure shows two “radio buttons” on the screen. These buttons allow you to select the
method of adjusting the display mode. From this screen you need to choose Units Full Scale or
Units/Div.
Adjusting Channel Setup for Channel 1
Remember, you can enable additional channels from the Channel configuration window. Enabling
additional channels allows you to acquire more data; however, it will not change your chart display on
Personal DaqView’s Chart Display Window. In other words, you can acquire data from channels, which
you do not monitor.