Measurement Computing Personal Daq rev.6.0 - Manual (Page 17)

Personal Daq User’s Manual 878395 Unit Startup 1-9
Channel Configuration
The Channel Configuration Window first opens with the Analog Input screen selected. You can change
from one configuration screen to another by selecting the appropriate tab. More information regarding
Personal DaqView appears in Chapter 4 of this manual. You can configure channels from the three
configuration screens as indicated in the following table.
Channel Type User Configurable Parameters
Analog Input User Label, On, Range, Units, Single-Ended/Differential, Measurement Duration, Scale,
Offset
Frequency/Pulse Input User Label, On, Type, Units, Edge, Debounce, Min. Value, Max. Value, Resolution
(Settling Time), Scale, Offset.
Frequency/Pulse Input does not apply to Personal Daq/54.
Digital Input/Output User Label, On, Input/Output, Output State, Power-Up State.
Digital I/O does not apply to Personal Daq/54.
Note: With the mouse cursor positioned in the desired spreadsheet cell, you can:
“Single-click” with the left mouse button to open an associated pull-down list for the applicable cell, from which a
selection can be made. This pull-down list appears just below the toolbar.
“Double-click” with the left mouse button to cycle through listed selections or write-enable a cell, as applicable. If
the cell has a given parameter list (such as those in the On, Range, and Measurement Duration columns) the
parameter will change with each double-click, allowing you to cycle through all possible selections. Note that
these selections are repetitive; in other words, you will eventually advance to the same selection you started
with. “Type-in” cells (such as User Label, Scale, and Offset) can be selected on double-click for easy editing.
“Single-click” left, then “single-click” right to write-enable a cell. Completing this action with the mouse buttons
(while having the cursor on a cell such as Scale or Offset) allows you to use you PC’s keypad to type the
desired value into the field.
“Single-click” left, “single-click” right, then “single-click” left again to open an associated pull-down list for the
applicable cell, from which a selection can be made. This pull-down list appears in the selected cell’s row.
Acquisition Configuration
To configure acquisition parameters, activate the Configure Acquisition Window by using toolbar
button (8).
Configure Acquisition Window