Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 51)

Section 4: Password Setups 39
Control Monitoring
When enabled, the Control Monitoring feature allows the user to view control status at the host PC.
Status for File Name, position, cut mode and cut information is displayed. This feature is only
available with the Phoenix Link communication software.
Please refer to the Phoenix Link information section of this guide for additional information on the
Phoenix link.
The following additional parameters are available when Serial Messaging has been enabled. See
Serial Messaging in the Program Code section of this guide for more information.
Flow control
Select to use None, Xon/Xoff or Hardware.
During Jog on Path
The user may select whether messages will be sent when jogging Forward or Backward on Path
while at the Pause screen. Note: All messaging will stop when the Stop Key has been pressed or
the Remote Pause input becomes active.
Note: The Message Type 21 will not be executed for “Backup on Path”.
Retry on Time Out
For the Message Type 22 (which requires an acknowledgement from the external device after the
message) an automatic retransmit of the message may be sent. The user may select the number of
retries allowed before faulting from a lack of response from the external device. The fault prompt
“Message Error” will be displayed when in a Time Out condition.
Time Out
The Time Out value may be used for the Message Type 22 (which requires an acknowledgement
from the external device after the message) if there is no Time Out value used in the command string
of the program code. Refer to the Delay Time / Time Out information for more information.