Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 203)

Appendix E: Voyager™ II Machine Interface 191
Optional Analog / PWM Interface
Analog Card Options
The Analog Card Interface option provides connection for operation of the Joystick, Speed Pot and
Sensor™ THC features
Series 1 ISA Analog Card
Note: The Analog Card will be designated as Rev 0 in the Control Information Diagnostic screen.
Board Marking PC-012-1098 Rev. B
Part # PCBS-0010-B
J1 - Power
Pin #
Designation Description
1 VA+ + 12VDC
2 A Ground Common
3 VA– - 12VDC
4 VE+ +5VDC
5 E Ground Ground
TB1 - I/O
Pin #
Designation Description
1 Analog 3 + Speed Pot 1 +
2 Analog 3 - Speed Pot 1 –
3 Analog 4 + Speed Pot 2 +
4 Analog 4 - Speed Pot 2 –
5 Input 1 Joystick Up ( single ended – active by E-ground )
6 Input 2 Joystick Down ( single ended – active by E-ground )
7 Input 3 Joystick Left ( single ended – active by E-ground )
8 Input 4 Joystick Right ( single ended – active by E-ground )
Mating Connector
8C Phoenix Connector – Phoenix Part # 1803633
TB2 - I/O
Pin #
Designation Description
1 Analog 2 + THC +
2 Analog 2 - THC –
3 Input 6 + Nozzle Contact Sense + ( Relay Contact )
4 Input 6 - Nozzle Contact Sense - ( Relay Contact )
5 Output 3 + Nozzle Contact Enable + ( Relay Contact )
6 Output 3 - Nozzle Contact Enable - ( Relay Contact )
7 Output 4 + Hold Ignition + ( Relay Contact )
8 Output 4 - Hold Ignition - ( Relay Contact )
Mating Connector
8C Phoenix Connector – Phoenix Part # 1803633