Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 167)

Appendix C: Program Codes 155
Example:
If the user were to add the Sub Part “L-Bracket” to be executed after completing a simple 5” x 5”
square with a commanded traverse, the part program would appear similar to this example.
( Rectangle - Piece )
G20
G91
G99 X1 Y0 I0 J0
G41
M07
G01 X-5.2 Y0
G01 X0 Y5
G01 X5 Y0
G01 X0 Y-5.2
M08
G00 X.75 Y0
PL-BRACKET
G40
M02
When executed, the example program provided above would be represented as the original part plus
the additional Sub Part, including the programmed traverse.
Note: Sub Parts may also contain other Sub Parts. After being translated by the control, the final
text of the part will contain the complete text of the original part and Sub Part.