Hypertherm HTA Rev 6.00 Install Guide User Manual
Page 184
172
Installation & Setup Guide
Drive/Encoder Connector
The Drive/Encoder connector is a reverse sex circular CPC connector from AMP. This connector
was specifically chosen for its rugged industrial design and its metal insulation characteristics for
EMI/RFI noise immunity.
NOTE: For optimum noise immunity, cable shields may be tied externally to the control enclosure or
to the metal AMP connectors.
Drive/Encoder Mating Connector and Cable
Connector AMP #208472-1
Backshell AMP #208945-8
Pins (16-18 ga) AMP #66099-3
Pins (20-24 ga) AMP #66103-3
Cabling: Use Belden # 9504 or equivalent for encoder signals
Cabling: Use Belden # 9501 or equivalent for drive signals
Axes Assignments
Axes Axes
Assignment
1 (X)
Transverse or Rail
2 (Y)
Transverse or Rail
3 (Z)
Dual Gantry, CBH or THC
4 (W)
CBH or THC