Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 163)

Appendix C: Program Codes 151
FineLine Part Program Support
The same Cut Chart data which is used at the Cut Chart setup screen may also be used within a part
program to configure the FineLine for use. This code is used to select the set point for each variable.
It is not necessary to have a line of code for each Cut Chart variable within a part program. Only
those variables which are changing need be inserted into the part program (e.g. Material Thickness or
Material Type).
Part program codes for the FineLine should be grouped together at the beginning of the program.
The three variables which may be set through the part program are Material Type, Current Setting
and Material Thickness.
Cut parameters for the FineLine may be configured using a EIA-274D G59 code with the following
format.
Example:
G59 V503 F5
Misc. G Code
Variable Identity
V503 – Material Type Plasma 1
V513 – Material Type Plasma 2
V523 – Material Type Marker 1
V533 – Material Type Marker 2
V504 – Current Setting Plasma 1
V514 – Current Setting Plasma 2
V524 – Current Setting Marker 1
V534 – Current Setting Marker 2
V507 – Material Thickness Plasma 1
V517 – Material Thickness Plasma 2
V527 – Material Thickness Marker 1
V537 – Material Thickness Marker 2
Variable Value
V503, V513, V523, V533 – Material Type
1 = Mild Steel
2 = Stainless Steel
3 = Aluminum
V504, V514, V524, 534 – Current Setting
8 = 8A 50 = 50A
9 = 9A 70 = 70A
10 = 10A 100 = 100A
30 = 30A 200 = 200A