Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 151)

Appendix C: Program Codes 139
EIA CODE DESCRIPTION
M38 Tvalue (1-20) Deselect Station “T” where T = 1 through 20
M40 Start of Subroutine
M40 Xvalue Start of Subroutine. Executes the repeat X times
M41 End of Subroutine
M50 Height Sensor Disable
M51 Height Sensor Enable
M52 Height Sensor Disable and Raise Torch
M53 Height Sensor Enable and Lower Torch
M65 End of Program (same as M02)
M72 Marker Offset 2 Off
M73 Marker Offset 2 On
M75 A Axis/Tilt Go to Home Command - Rapid Index
M76 C Axis/Rotate Go to Home Command - Rapid Index
M77 Go to Home position Y Axis
M78 Go to Home position X Axis
M79 Tvalue (1-4) Go To Home Position ( 1-4)
M90 Aligns CBH / Rotator to Tangent angle of next cut segment
M274 Marker Offset 3 Off
M275 Marker Offset 3 On
M276 Marker Offset 4 Off
M277 Marker Offset 4 On
M278 Marker Offset 5 Off
M279 Marker Offset 5 On
M280 Marker Offset 6 Off
M281 Marker Offset 6 On
M282 Marker Offset 7 Off
M283 Marker Offset 7 On
M284 Marker Offset 8 Off
M285 Marker Offset 8 On
M286 Marker Offset 9 Off
M287 Marker Offset 9 On
M288 Marker Offset 10 Off
M289 Marker Offset 10 On
M290 Marker Offset 11 Off
M291 Marker Offset 11 On
M292 Marker Offset 12 On
M293 Marker Offset 12 On
M301 Assigns the current X/Y position to Home Position 1
M302 Assigns the current X/Y position to Home Position 2
M303 Assigns the current X/Y position to Home Position 3
M304 Assigns the current X/Y position to Home Position 4
Mapped EIA Codes
EIA CODE
DESCRIPTION MAPPED TO
G04 Fvalue Program Dwell G04 Xvalue
G05 Set Axis Presets G92
G21 Linear Interpolation G01
(at cut speed)
G22 CW Circular Interpolation G02
G23 CCW Circular Interpolation G03
G41 Kvalue Left Kerf with Value G41 with Kerf Value
G42 Kvalue Right Kerf with Value G42 with Kerf Value
G97 TValue Subroutine Loop G08 Xvalue and M40