Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 202)

190 Installation & Setup Guide
Drive/ Encoder Pinout ( J5- J10 )
Pin Description
1 Channel A Input
2 Channel B Input
3 Channel Z Input
4 Encoder Power Output ( 5 VDC supplied as standard )
5 Chassis Ground / E Ground
6 Servo Output ( ± 10V)
7 Drive Enable In ( relay contact )
8 Encoder Shield
9 Channel /A Input
10 Channel /B Input
11 Channel /Z Input
12 E Ground
13 Drive/ Servo Shield
14 Servo Output Common
15 Drive Enable Out ( relay contact )
Drive/ Encoder Input Mating Connector
Connector: 15C D-Sub Amp # 25206-3 or equivalent
Backshell: Amp #748676-2 or equivalent
Pins: Amp #5-66506-9 ( 20-24 AWG ) or equivalent
Warning! This control is equipped with an internal power supply for providing analog, encoder and
I/O voltage. A wiring modification to bring the proper voltage to the Drive Encoder Connector for the
use of 12 Volt encoders may be required.