Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 197)

Appendix E: Voyager™ II Machine Interface 185
Appendix E: Voyager II™ Machine
Interface
The Voyager II™ Shape Cutting Control is designed with all machine interface connections internal to
the enclosure. No external machine interface is provided. All Interface cabling enters and exits
through an opening in the bottom of the enclosure. Extreme caution should be taken to ensure that
the opening at the base of this unit is appropriately sealed so that no contamination enters the unit.
The information contained in this section is intended to provide the basic information for connection of
the Voyager II™ Shape Cutting Control to the cutting table. Each machine interface will vary slightly
based on the cutting table configuration and features. Additionally, I/O pinout information may vary
slightly based on the configuration of the selected I/O and their locations. Changes to the I/O
configuration may be made in the password protected I/O screen. All controls are shipped with the
default selection of Inputs and interface locations for the selected control Interface (I/O) configuration.
Installation and service should only be performed by a qualified service technician. For more
information regarding the I/O process definitions please refer to the Setups section of this guide.
Operation and maintenance of automated equipment involves potential hazards. Personnel should
take precautions to avoid injury. This equipment should only be opened by trained service personnel.